Structural (refined) covering white mortar (abrasive) CR-CS I-W0 according to EN 998-1. Used for interior walls and ceiling surfaces, on top of cement, gypsum and lime mortars, as well as on top of pre-fabricated construction (gypsum) boards.The base must be dry and cleaned from dust and waste. The entire surface of any gypsum or cement mortars must be previously dried and cleaned, and gypsum boards need to be previously levelled with Renofix 18 or Renofix 15 white. Renofix 360 is applied on base mortars once these are dried up.

Dry mortar prefabricated according to EN 998-1. Mineral, non-hydrophobic, structural, and final mortar for facades and interior areas, applied on base mortars and heat isolation ones.Pour a bag of Renofix 370 into 6.3 6.7 litres of clean water and mix it with a mixer until it becomes a homogenous mass. Once mixed, leave it for about 10 minutes. Then stir shortly again and apply on the base.The mortar is applied with a steel trowel. It is structured by an appropriate felting parget (made of polystyrene or plastic). The layer thickness depends on the size of the grain (granulation). It must not be used at temperatures lower than +5 C. It is not to be mixed with other materials.

Renofix 740 is a modern building material of high qualities (refined mortar CR CS II- W1, EN 998-1) applied on external and internal areas. Pour a bag of Renofix 740 into 6.3-6.7 litres of clean water and mix it with a mixer until it becomes a homogenous mass. Stir shortly again after 10 minutes. The mortar is applied with a stainless steel trowel. It is structured by an appropriate felting parget made of polystyrene or plastic. It is not to be mixed with other materials. It must not be used at temperatures lower than +5 C.